Sep_11_1999_H51.txt Shift H52 Start at 1999:254:07:00:00 GMT = 1999 Sep 12 04:00am EDT End 1999 Sep 12 06:10am EDT SOT Lead Bill Podgorski SOT SC/ACA FOT-SI HRC-SI Gerry Austin ACIS-SI Paul Plucinsky, Fred Baganoff Status/Plans: ------------ - Run ACIS diagnostics per CAP 412. - Running P13 load - SOT covers contact time only EVENTS DONE OBSID -------------- ---- ----- Start Shift 254:0700 53 - P13 load ----- Out of Contact------ AOS DSS-46 254:0825 ----- Real time------ Confirm configuration 254:0825 (see details below) Start CAP 412, ACIS Diagnostic test 255:0844 Change OBSID to 62428 255:0856 62428 ACIS Start science, CAP step 6 255:0859 (~2000s Timed Exposure on S2 and S3, faint mode) Scheduled turn-off of COMM in daily load 255:1010 Real-time transmitter turn-on 255:1011 ACIS Stop science (step 10) 255:1020 Change OBSID to 62427 255:1023 ACIS Start Science, CAP 412 step 13 255:1024 (Event histogram, S detector) Execute CAP 413 to set ACIS FP temp to -120C 255:1030 Reset format to 1 255:1046 Set OBSID to 62426 for HRC Observation 255:1048 Complete CAP 412 255:1051 Loss of commanding 255:1053 LOS DSS-46 255:1010 ----- Out of Contact------ NOTES/ISSUES/PROBLEMS --------------------- 1) At AOS the spacecraft configuration was nominal. It was in Normal Point mode with OBSID = 53. The SIM TSC was at -99616 (HRC-S) and the FA at -882. There were 5 stars observed and 3 FIDs. RA: 79.201492 DEC: 45.980237 ROLL: 95.781850 HOWEVER - format was 2, was not reset to 1 after last ACIS CAP(410). Load P13 did not set format back to 1 since last observation when P12 was terminated (253:1950) (OBSID 1253) had been an HRC-I observation. This format problem made the initial part of OBSID 53 invalid. Will reset format to 1 before LOS and change OBSID to 62426 as replacement for 53. PROBLEM - LETG is NOT in as it should be. 2) Real time observation of LETG/HRC-S indicates a possible source at about 40 arcmin off-axis in -Y direction, falling on -Y HRC-S channel plate. This may be the object mentioned in the quick-look analysis of OBSID 62435, 3) At LOS the ACIS Focal plane temp was -107.4C. 4) After LETG problem was noticed Bruce Twambly, Keith Havey were contacted to work problem. Bill Peterson FOT flight software, will also work problem.