The ACIS CCDs provide the capability to perform medium resolution spectroscopy () over almost the entire AXAF bandpass with high Quantum Efficiency (QE). ACIS can simultaneously image and acquire spectra from regions in pixels. Either the ACIS imaging or spectroscopy arrays may be used for these observations. The ACIS-I array is comprised of 4 CCDs arranged in a square which provide a arcminute field. The ACIS-S array is comprised of six CCDs of the same type lined up in a configuration. Although designed to be used primarily with the gratings, the ACIS-S array may be used for imaging, providing the advantage that the focal point will be farther from the edge of a CCD than in the ACIS-I array. ACIS should be the instrument of choice for spectral studies of extended objects.
Figure 9. The quantum detection efficiency as a function of energy for front-side (solid line) and back-side (dashed line) illuminated CCDs, for events which produce a charge of more than 40 ADUs (analog to digital units) in either one or two pixels. [Figure courtesy of Andy Rasmussen, MIT]
Figure 10. The energy resolution as a function of energy for single pixel events, for four different values of the readout noise. The points show early laboratory measurements.
The QE of the ACIS CCDs is limited at low energies by the filter and the CCD design, and is limited at high energies by the finite thickness of the CCDs. Figure 9 plots the QE as a function of energy for front-side (FI) and back-side illuminated (BI) CCDs. Both CCD designs provide high QE over most of AXAF's bandpass, but the BI CCDs have a clear advantage over the FI CCDs. Unfortunately BI CCDs are more difficult to fabricate than FI CCDs with the current technology. A selection of CCD design will be made later this year.
The energy resolution of the ACIS CCDs is a function of energy and is limited by the statistical fluctuations in the number of electrons produced when an X-ray is absorbed in silicon. The energy resolution also depends on the readout noise of the CCDs, but improvements in CCD fabrication techniques have reduced this term to the point where it is a small contributor. Figure 10 plots the energy resolution as a function of energy for four different values of the readout noise. The ACIS CCDs are expected to have a readout noise of less than 2 electrons and are therefore almost at the theoretical limit of the energy resolution of CCDs.
The CCD instrument aboard the ASCA satellite has already ushered in a new age of X-ray spectroscopy. ACIS promises several improvements over the ASCA instrument. First, the quality of the AXAF images will improve the sensitivity to point sources by focusing the source photons into a much smaller region, thereby facilitating the separation of source and background photons. Second, the effective area of the HRMA/ACIS combination is larger than on ASCA. Third, ACIS will have more available telemetry bandwidth, which allows the utilization of CCD modes which preserve all the pulse-height information, and ACIS will be able to update the bad pixel maps used to exclude `hot pixels'. Fourth, BI CCDs would extend the bandpass below the keV cutoff of ASCA. Finally, the readout noise of the ACIS CCDs will be lower, thereby improving the spectral resolution.