Skip to the navigation links
Last modified: 16 November 2022


Bugs: Building CIAO from Source

Table of Contents




pkg-config must be version 0.18 or newer

To find out the version on your system:

pkg-config --version

If it is older then 0.18 or is not installed, you can use the pkg-config included with the CIAO OTS.

setenv PATH <location of ciao>/ciao-4.15/ots/bin:$PATH

This must be done before running configure.

Download the binary tarfiles to use the precompiled OTS

If you are building from source but wish to use the compiled OTS packaged with CIAO (e.g. the CIAO copy of Python), it is necessary to download both the source and binary files.



The $ASCDS_INSTALL/INSTALL_SOURCE instructions that are included in the CIAO distribution may be incomplete or out of date. The most up to date instructions are located in the Rebuilding CIAO 4.15.2 source with pre-built OTS binaries on Linux and Rebuilding CIAO 4.15.2 source with pre-built OTS binaries on mac threads.

make or make install?

After running ./configure with the correct flags to setup for a source build users may, depending on the packages they downloaded, see a message about running make or make install. Users must run

unix% ./configure --with-fits --with-ascii ...etc...
unix% make install

Building sherpa using pre-compiled XSPEC library requires same version of gfortran

Users building sherpa from source with the CIAO pre-compiled binary OTS packages (recommended) may run into a problem that the version of FORTRAN used to build XSpec must be the same as is used to build sherpa.

Specifically this means that sherpa must be built to link against

Users may need to recompile the XSpec models library with the same version of gfortran.